|
关注：1
2013-05-23 12:21
求翻译：可能为刀座第二次对内孔进行加工时导致个别内孔径偏大，根本原因可能为我司在更换铣刀时未校正到位。是什么意思？ 待解决
 悬赏分：1
- 离问题结束还有
可能为刀座第二次对内孔进行加工时导致个别内孔径偏大，根本原因可能为我司在更换铣刀时未校正到位。
问题补充： |
|
2013-05-23 12:21:38
May lead to the individual within the aperture is too large knife block, a second internal hole processing, the root cause may be in place for the Division I uncorrected replacement cutter.
|
|
2013-05-23 12:23:18
May 2 is the first time in the hole in the processing result in relatively large bore within individual root cause may be, for I am the secretary when you replace the cutter is not correct.
|
|
2013-05-23 12:24:58
Possibly second time carries on when the processing to in hole causes the individual in aperture for the tool apron to be big, the basic reason possibly takes charge of for me when replaces the milling cutter has not adjusted the arriving.
|
|
2013-05-23 12:26:38
When processing for knife block on the hole for the second time within individual aperture large, root causes may we replace milling cutter without correction in place.
|
|
2013-05-23 12:28:18
正在翻译，请等待...
|
湖北省互联网违法和不良信息举报平台 | 网上有害信息举报专区 | 电信诈骗举报专区 | 涉历史虚无主义有害信息举报专区 | 涉企侵权举报专区
