|
关注:1
2013-05-23 12:21
求翻译:控制器发讯点在出厂前就已根据订货要求调试好, 不得随意拆卸。若控制器在使用过程中, 确需改变设定点位置时, 可在导管长度的允许范围内进行调节。调节前必须切断电可在导管长度的允许范围内进行调节。调节前必须切断电源, 然后再按下列步骤进行:是什么意思? 待解决
悬赏分:1
- 离问题结束还有
控制器发讯点在出厂前就已根据订货要求调试好, 不得随意拆卸。若控制器在使用过程中, 确需改变设定点位置时, 可在导管长度的允许范围内进行调节。调节前必须切断电可在导管长度的允许范围内进行调节。调节前必须切断电源, 然后再按下列步骤进行:
问题补充: |
|
2013-05-23 12:21:38
Controller sender point according to the requirements of orders in the factory had the debugging not disassemble. If the controller is needed to change the set-point position during use, can be adjusted within the permissible range of the length of the catheter. Regulation must be cut off before ele
|
|
2013-05-23 12:23:18
A controller in the factory has been based on the booking request better debugging, not removing. When the controller is in the process, that is when you change the setting point location, length of the pipe to allow for adjustment. Adjust the need to cut off electricity to the catheter length allow
|
|
2013-05-23 12:24:58
The controller sends a message on has debugged before the exwork according to the ordering request, does not have to disassemble at will.If the controller in the use process, must change time firmly the setpoint position, may carry on the adjustment in the drive pipe length permission scope.Before t
|
|
2013-05-23 12:26:38
Points made by the controller in the factory which has been under orders to debug properly shall not disassemble. If in the process of controllers in use, when really necessary to change the location set points, can be adjusted in the catheter length within the range of allowed. Regulation must be c
|
|
2013-05-23 12:28:18
正在翻译,请等待...
|
湖北省互联网违法和不良信息举报平台 | 网上有害信息举报专区 | 电信诈骗举报专区 | 涉历史虚无主义有害信息举报专区 | 涉企侵权举报专区