求翻译：由于试验中的用户终端较少，真空储存罐体积相应较小。从上述计算可以看出，在Q=1.5 L时，即可基本满足便器完全冲洗干净的需要。但在计算用水量时，取实验数值最大值Q=2 L计算，即每次冲厕用水量都为2L，以保证便器尽可能不再有二次冲洗的现象。是什么意思？

As the pilot of the small user terminals, storage tank volume of the corresponding small vacuum. As can be seen from the above calculation, the Q = 1.5 L, they can basically meet the needs of the toilet completely clean. However, in the calculation of water when taking the maximum experimental value

Because the test in the user terminal is relatively small vacuum storage tank size is small. It can be seen from the above calculations, the Q L = 1.5 when it is, you can basically meet the needs fully rinse in clean water. But in calculating experiments to the quantity of water from the largest val

Because experiments the user terminal to be few, vacuum storage pot volume corresponding small.May see from the above computation, when Q=1.5 L, then basically satisfies the bedpan to flush the clean need completely.But when computation water consumption, takes experimental value maximum value Q=2 t

As the test user terminal in less, vacuum storage tank volume is smaller. You can see from the above calculation, at the time of Q=1.5 l, you can basically meet the toilet flush needs exactly. However, when calculating the consumption, pick up experimental numerical calculation of maximum Q=2 l, tha

Because experiments the user terminal to be few, vacuum storage pot volume corresponding small.May see from the above computation, when Q=1.5 L, then basically satisfies the bedpan to flush the clean need completely.But when computation water consumption, takes experimental value maximum value Q=2 t