当前位置:首页 » 翻译 
  • 匿名
关注:1 2013-05-23 12:21

求翻译:调整压线间隙到最小,此时压线间隙最小接近开关动作,压线间隙自动校正;再增大压线间隙,压线间隙显示值从最小值开始变大表示编码器信号线未接反,反之,则需调换编码器的A,B相。是什么意思?

待解决 悬赏分:1 - 离问题结束还有
调整压线间隙到最小,此时压线间隙最小接近开关动作,压线间隙自动校正;再增大压线间隙,压线间隙显示值从最小值开始变大表示编码器信号线未接反,反之,则需调换编码器的A,B相。
问题补充:

  • 匿名
2013-05-23 12:21:38
Gap adjusting the pressure line to a minimum, the minimum pressure line clearance proximity switches automatically correct action, pressure line clearance; increase the pressure line gap pressure line clearance value from the minimum becomes larger, said encoder signal line is not connected to anti-
  • 匿名
2013-05-23 12:23:18
Adjust line spacing to the smallest, at this point the line close to the minimum clearances, pressure switch auto-correction line clearance; and raise the pressure line clearance, crimp the value gap from the smallest value that is the encoder signal wire is not reversed, vice versa, you need to swa
  • 匿名
2013-05-23 12:24:58
Adjustment line ball gap to smallest, this time the line ball gap is smallest the close switch movement, the line ball gap automatic correction; Again increases the line ball gap, the line ball gap demonstrated the value starts from the minimum value to increase the expression encoder holding wire n
  • 匿名
2013-05-23 12:26:38
Adjust the pressure gap to a minimum, minimum pressure gap close to the switch, pressure automatic clearance correction; increasing the pressure gap, pressure values displayed on the sidelines from the minimum size that the encoder signal cable is not connected backwards, but you will need to change
  • 匿名
2013-05-23 12:28:18
正在翻译,请等待...
 
 
网站首页

湖北省互联网违法和不良信息举报平台 | 网上有害信息举报专区 | 电信诈骗举报专区 | 涉历史虚无主义有害信息举报专区 | 涉企侵权举报专区

 
关 闭