求翻译：根据我部对一些锯缝设备供应商的咨询，在POCKET外，一次成缝最大宽度为10mm，要想达到设计要求的15mm需要进行两次锯缝，这对控制缝的直线性非常不利，建议把15mm缝宽修改为10mm缝宽，如下图所示。是什么意思？

According to our department for some of the saw kerf equipment supplier of consulting, in POCKET, the time to maximum slit width of 10mm, 15mm in order to meet the design requirements of the two saw the need for sewing, sew a straight line which control is very negative, it is recommended 10mm to 15

正在翻译，请等待...

According to our unit to some kerf equipment supplier's consultation, outside POCKET, one time becomes the seam extreme breadth is 10mm, must want to achieve the design request 15mm needs to carry on two times the kerf, this to controls the seam the straightness to be extremely disadvantageous, sugg

Under part I saw slit device vendor Advisory, outside the POCKET, once a maximum width of 10MM joints, to meet the design requirements of the 15mm require two saw joint, which is adverse to the control joints of straight lines, it is recommended that modify 10MM 15mm slit width slit width, as shown

正在翻译，请等待...