求翻译：根据我部对一些锯缝设备供应商的咨询，在POCKET处，一次成缝最大宽度为10mm，要想达到设计要求的15mm需要进行两次锯缝，这对控制缝的直线性非常不利，建议把15mm缝宽修改为10mm缝宽，如下图所示。是什么意思？

正在翻译，请等待...

According to my department on a number of blade equipment suppliers in the advisory, POCKET Department, a maximum width of 10 mm stitch, if they want to reach the 15 mm design requirements would require two blade, to control the sewing linear very negative, it is recommended that the 15 mm to 10 mm

According to our unit to some kerf equipment supplier's consultation, in POCKET place, one time becomes the seam extreme breadth is 10mm, must want to achieve the design request 15mm needs to carry on two times the kerf, this to controls the seam the straightness to be extremely disadvantageous, sug

Under part I saw slit device vendor Advisory, POCKET Office, once a maximum width of 10MM joints, to meet the design requirements of the 15mm require two saw joint, which is adverse to the control joints of straight lines, it is recommended that modify 10MM 15mm slit width slit width, as shown in th

正在翻译，请等待...