当前位置:首页 » 翻译 
  • 匿名
关注:1 2013-05-23 12:21

求翻译:按压F1自动键,无法捕捉到稳定的波形。A,波形输入幅值过小;B,被测信号频率低于20Hz;C,探头衰减设置不对;D,超出测量频率范围;E,被测信号干扰大;F,探头损坏或连接有误;G,整机故障。是什么意思?

待解决 悬赏分:1 - 离问题结束还有
按压F1自动键,无法捕捉到稳定的波形。A,波形输入幅值过小;B,被测信号频率低于20Hz;C,探头衰减设置不对;D,超出测量频率范围;E,被测信号干扰大;F,探头损坏或连接有误;G,整机故障。
问题补充:

  • 匿名
2013-05-23 12:21:38
Press the F1 key automatically, can not capture a stable waveform. A, the input waveform amplitude is too small; B, the measured signal at frequencies below 20Hz; C, the probe attenuation setting right; D, beyond the measurement frequency range; E, the measured signal interference large; F, the prob
  • 匿名
2013-05-23 12:23:18
acupoints F1 automatic type, unable to capture stable waveform. A, waveform input in such a small value; B detected signals, frequency of less than 20 Hz; C probe attenuation settings, not to exceed; D measuring frequency range; E detected signal interference, the damage or connections; F probe, mis
  • 匿名
2013-05-23 12:24:58
Holds back the F1 automatic key, is unable to catch the stable profile.A, the profile input peak-to-peak value excessively is small; B, was measured the signaling frequency is lower than 20Hz; C, the probe head weakens the establishment not to be right; D, surpasses the survey frequency range; E, wa
  • 匿名
2013-05-23 12:26:38
Pressing F1 key, cannot capture the waveform into the stable. A, waveform input amplitude is too small; b, the measured signal frequency is lower than 20Hz;C, probe attenuation setting wrong; d, exceeds the measurement frequency range; e, the measured signal interference; f, the probe is damaged or
  • 匿名
2013-05-23 12:28:18
Press the F1 key automatically, can not capture a stable waveform. A, the input waveform amplitude is too small; B, the measured signal at frequencies below 20Hz; C, the probe attenuation setting right; D, beyond the measurement frequency range; E, the measured signal interference large; F, the prob
 
 
网站首页

湖北省互联网违法和不良信息举报平台 | 网上有害信息举报专区 | 电信诈骗举报专区 | 涉历史虚无主义有害信息举报专区 | 涉企侵权举报专区

 
关 闭