求翻译：1）上电显示“888…”4秒，,进入运行状态，按一下设定键，控制器进入温度设定状态，温度设定指示灯亮，控制器左窗口显示温度设定值，温度设定值闪，用户可根据需要修改参数（设定值为0～60.0℃）。再按一下该键，控制器进入时间设定状态，时间设定指示灯亮，控制器右窗口显示设定的时间值，用户可根据需要修改参数(设定值为0～9999)〈如工作时间设定为0000，则表示定时器不工作，在此状态下运行时，右窗口显示设定温度；运行时间为上电后运行的时间，所以重新设定时间时应加以考虑〉。再按一下该键，退出设定状态。长按设定键4秒，进入内部参数设定状态。再长按该键4S将退出此状态。在上述两种状态时，如果30S内无按键按下，控制器将自动退出上述设定状态，修改的参数不保存。当运行时间结束后，时间窗口显示“End”，蜂鸣器鸣叫1分钟。此时可以按增加键8秒钟，程序将重新运行。是什么意思？

1) displayed on the "888 SB" 4 seconds, into the running state, press the set key, controller enter a temperature setting State, temperature setting light, controller window on the left shows the temperature set value, Flash temperature set value, the user can modify the parameters as needed (sets the value for 0~60.0 ℃). Then by about the key, controller entered time set state, time set indicates lamp lit, controller right window display set of time value, user can under need modify parameter (set value for 0~9999) ' as work time set for 0000, is said timer not work, this State Xia run Shi, right window display set temperature; run time for Shang electric Hou run of time, so again set time Shi should be consider. Press the key again to exit the set state. Long press set to 4 seconds, into the internal parameter set state. 4S long press the key again will exit this State. In either State, if no key pressed in the 30S, the controller will automatically exit the above set state, modify the parameter is not saved. When run after the end of time, time window displays "End", buzzer call 1 minute. You can press the add key for 8 seconds, the program will be rerun.